IXIA BreakingPoint Storm, Руководство по установке

Страница: 36 / 62

FireStorm ONE Installation Guide 27 BreakingPoint Systems Inc. ©2005-2016
By following the safety recommendations outlined in this section, you can reduce the likelihood of
accidents and ensure the proper installation of the FireStorm ONE.
Our recommended safety instructions for handling, operating, and maintaining the FireStorm ONE
are listed below:
• Keep the area around the appliance clear and dust-free during and after the installation.
• Only trained and qualified personnel should handle or service the FireStorm ONE.
• Wear safety glasses when working under any conditions that may be considered hazardous to
your eyes.
• Use proper electrostatic discharge (ESD) protection when handling the appliance.
• Only trained and qualified personnel, who have thoroughly reviewed the
FireStorm ONE
Installation Guide , should install, perform maintenance, or request service for the appliance.
• Do not touch uninsulated wires or terminals unless all cables and connections have been
disconnected from the appliance.
• Do not remove the fan tray while the FireStorm ONE is powered on. Power the system off and
wait until the fans have stopped running before removing the fan tray from the system.
• The appliance should be installed at least 2 feet above the ground.
Safety Regulations
Table 3-1 on page 27
lists the safety regulations to which the FireStorm ONE is compliant.
Table 3-1: Safety Regulations
Regulation Description
CE Mark Certification The CE mark certification indicates that a product meets
the European Union’s (EU) health, safety, and
environmental requirements.
FCC Rules: Part 15, Class A Part 15 of the FCC Rules stipulates that devices must not
cause harmful interference to any radio services, and it
describes the technical specifications and administration
requirements for Part 15 devices. For more information on
Part 15 of the FCC Rules, visit the FCC’s Web site.
EIA-310-C Requirements These requirements define the industry specifications for
standard 19-inch equipment racks. The height is measured
in units and each unit (U) on the rack is 1.75 inches.
UL-60950-1 This regulation describes the safety standards for low-
voltage information technology equipment. This standard
specifies requirements intended to reduce risks of fire,
electric shock, or injury to the operator or layman who may
come into contact with the equipment.