87
Control Operation
If the output is continuously on for longer than the Output Time Limit, then output will deactivate.
Output Details
The details for this type of output include the output %, HOA mode or Interlock status, alarms related to this out-
put, current cycle on time, total accumulated on-time, cycles of concentration, mA output, and the current control
mode setting.
Settings
Touch the Settings icon to view or change the settings related to the relay.
Target
Enter the desired PPM set point for the product.
Pump Capacity
Enter the maximum flow rate for the metering pump.
Pump Setting
Enter the stroke length setting for the metering pump, in percent.
Specific Gravity
Enter the specific gravity of the product to be added.
Hand Output
Enter the output % desired when the output is in Hand mode.
Off Mode Output
Enter the output mA value desired when the output is in Off mode, or being Interlocked, or
during a calibration of the sensor being used as an input. The acceptable range is 0 to 21 mA.
Error Output
Enter the output mA desired when the sensor is not giving the controller a valid signal.
The acceptable range is 0 to 21 mA.
Flow Input
Select the flow meter to be used as an input for this control relay.
5.4 Configuration Menu
The configuration Settings Menu is used for settings and activities that are not tied to Inputs or Outputs.
5.4.1
Global Settings
Date
Enter the current year, month and day.
Time
Enter the current hour (military time), minute, and second.
Name
Enter the name to help identify the controller when it connects to Fluent.
Location
Enter the location to help identify the controller when it connects to Fluent.
Global Units
Select the units to be used for cable length and wire gauge settings, metric or Imperial.
Temperature Units
Select between Fahrenheit and Celsius.
Alarm Delay
Enter how much time to wait after powering up the controller before alarm conditions are
considered valid.
Pump Units
Select between liters/hour, gallons/hour, or ml/minute.
Language
Select the language the software will use.
5.4.2
Security Settings
Controller Log Out
When Security is Enabled, and after the password has been entered, the controller requires
immediate use of a password to calibrate or change settings. Once finished making changes,
log out to prevent unauthorized changes by someone else. If not manually logged out, the
controller will automatically log out after 10 minutes of inactivity.
Security
Select Enable to require a password in order to calibrate or change settings, or Disable to
allow calibration and set point changes without a password. In order to enable security, the
default password must be entered first, then touch Enabled, then touch the Confirm icon.
