Iveco EUROCARGO, Инструкция по эксплуатации

Страница: 26 / 226

18
EUROCARGO Euro 6
–
GENERAL INFORMATION
GENERAL INFORMATION
1.16
INSTRUCTIONS FOR PROPER FUNCTIONING OF THE VEHICLE PARTS AND ACCESSIBILITY
–
Printed 603.95.747
–
1st Ed. - Base 12/2013
196798
Figure 7
1. Body surface
2. Lateral protrusion AdBlue tank
3. Lateral protrusion diesel oil pre-filter
4. Lateral protrusion silencer protection
Table 1.2 - Sizes of the most protruding units
Vehicle Y
max
left side member Y
max
right side member
From 60E to 100E 1125 mm 1125 mm - AdBlue cap
From 110EL to 160 E 1145 mm
1150 mm - pre-filter
1128 mm - AdBlue cap
180, 190EL 1125 mm
1160 mm - pre-filter (280 litre tank)
1150 mm - pre-filter (200 litre tank)
1128 mm - AdBlue cap
110W, 150W 1145 mm 1225 mm - pre-filter
●
the possibility of disassembly of the various units must be maintained for any support interventions (e.g. in figure 6 ref. 2 is
shown the case of the DPF / silencer assembly, with the minimum necessary dimension for the correct use of the tools);
●
conditions should not be affected regarding cooling (radiator grille, radiator, air passages, cooling etc.), fuel supply (pump posi-
tioning, filters, pipe diameter, etc.) and engine air intake;
●
the soundproofing panels must not be altered or moved so as not to affect the approved sound emission limits. If any open-
ings need to be made (e.g. for the passage of pipes or added sections), they must be thoroughly closed, using fireproof and
soundproofing materials equivalent to the original materials used;
●
adequate ventilation must be maintained for the brakes and battery casing (particularly in the execution of truck bodies);
●
in the placement of fenders and wheel arches, free shaking of the rear wheels must be guaranteed, even under the conditions
of use with chains. It must also be guaranteed enough space for the lifting axle tyres. Some models include steering of the 3rd
axle in the raised position as well: respect the spaces necessary for this function (see Chapter 2.21);
●
adjustment of the vehicle's headlamps must be checked once construction is completed, to correct any changes in their struc-
ture; for adjustment, proceed according to the instructions given in the "Use and Maintenance" manual;
●
for any elements supplied loose (e.g. spare wheel, chocks), the Bodybuilder must position and fasten them in an accessible and
secure way, in compliance to any national regulations.