e) Slide the angular contact duplex bearings (112) onto the shaft while you maintain the correct
orientation.
f)
Push the inner races firmly together against the shoulders until they cool and lock into place.
g) After the bearings have cooled, place the lockwasher (382) on the shaft and install the bearing
locknut (136).
h) Tighten the bearing locknut firmly with a spanner wrench while you clamp the bearing set
against the shaft shoulder.
i)
Bend the tang of lockwasher into a slot on the bearing locknut.
1
409
122
253B
112
382
136
1.
Spacing ring.
2.
If the frame is grease lubricated, hand pack all three bearings with grease.
3.
Lubricate and install the O-ring (496) on the thrust bearing housing (134A):
a) Slide the thrust bearing housing over the bearings.
b) Attach the thrust-bearing retaining ring (253B) to the thrust bearing housing with socket head
capscrews (236A).
Tighten firmly in a crossing sequence in order to make sure there is even contact with the bearing
races. See Maximum torque values for fasteners.
For the S, M, L, and XL groups:
For the XL1, XL2-S, and XL2 groups:
There will be a gap of approximately 0.12 to 0.16 in.
(3.05 to 4.06 mm) between the retaining ring and
bearing housing.
There will be a gap of approximately 0.16 to 0.21 in.
(4.06 to 5.33 mm) between the retaining ring and
bearing housing.
Assembled rotating element:
6.6 Reassembly
98
Models 3180, 3181, 3185, and 3186 Installation, Operation, and Maintenance Manual
Содержание GOULDS PUMPS 3180
Страница 1: ...Installation Operation and Maintenance Manual Models 3180 3181 3185 and 3186 ...
Страница 2: ......
Страница 153: ...9 1 Certificates of conformance Models 3180 3181 3185 and 3186 Installation Operation and Maintenance Manual 151 ...
Страница 155: ...9 1 Certificates of conformance Models 3180 3181 3185 and 3186 Installation Operation and Maintenance Manual 153 ...