46
MABS2_E06_V
×××
Setting the IP address / Checking connection
↓
Creating the project file
↓
Registering IB-E06F-M1 to be used
↓
Registering comments
↓
Network settings
Complete
↓
Motor settings
↓
Swing angle settings
↓
■
The following figure indicates an entry example when the master unit is set
to Node 1.
Property setting
Network settings
Double-click the master unit.
Select “MABS2_E06_V
×××
” for the logic.
Select the Error/Network tab.
1
Put a checkmark in Multicast.
2
Enter the address for the unit to be synchronized in Receive node.
(If the IP address for the synchronized unit is “192.168.1.xxx”, enter “225.0.1.xxx” in Receive node.)
When using multiple synchronized units, enter the address for the respective node.
3
4
5
Double-click the synchronized unit.
Select “MABS2_E06_V
×××
” for the logic.
MABS2_E06_V
×××
Select the Error/Network tab.
1
Put a checkmark in Multicast.
2
Enter the address for the master unit in Receive node.
(If the IP address for the master unit is “192.168. 1.1”, enter “225.0. 1.1” in Receive node)
3
4
5
■
When using only one unit, or operating MABS units individually without connecting
each unit using the LAN cable, the Network settings are not necessary.
Make sure that all the master unit controllers and synchronized unit controllers
for the registered IB-E06F-M1 have been set to Master. If any have been set to
Slave, select the appropriate node, and right-click to set to Master.
(The default value is Master for all controllers.)
1
2
3
1
Master unit
Network settings
■
The following figure indicates an entry example when the synchronized unit
is set to Node 2.
Synchronized unit
Network settings.
1
2
3
5
4
1
2
3
5
4
8. IB-E06F-M1 settings
MABS technical document
Safety precautions
Advanced preparation
Product check
Structures
Installation/Wiring
Control/Operation
Maintenance/Inspection
Troubleshooting
Appendix
IB-E06F-M1 settings
MABS2_E06_V
×××
Original notice - U1.1
