SECTION 10—UPHOLSTERY/SEAT POSITIONING STRAP
Part No. 1106645
49
R51™and R51LXP
SECTION 10—UPHOLSTERY/SEAT
POSITIONING STRAP
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Replacing Seat Upholstery
NOTE: For this procedure, refer to FIGURE 10.1.
1. Remove the phillips screws and
washers that secure the existing seat
upholstery to the crossbraces.
2. Remove existing seat upholstery from
the crossbraces.
3. Line up mounting holes in new seat
upholstery with mounting holes in the
crossbraces.
4. Securely tighten with existing phillips
screws and washers.
NOTE: Clean upholstery with warm DAMP
cloth and mild detergent to remove superficial
soil.
FIGURE 10.1
Replacing Seat Upholstery
WARNING
Laundering or moisture will reduce flame retardation of the upholstery.
Replacing Back Upholstery
NOTE: For this procedure, refer to FIGURE 10.2 on page 50.
NOTE: Observe the position and orientation of the back cane mounting hardware before removing.
The fold down back canes use two mounting screws to secure the two back canes to the wheelchair
frame, all other back canes use four mounting screws.
1. Remove the two upholstery mounting screws and washers that secure the existing
back upholstery to the back canes.
2. Remove the screws and locknuts that secure the two back canes to the wheelchair
frame.
3. Remove the two back canes and the back upholstery from the wheelchair frame.
Phillips Screw
Washer
Seat Upholstery