SECTION 7—FRONT RIGGINGS
Part No. 1106645
41
R51™and R51LXP
Adjusting Calfpads
1. Turn calfpad towards the outside of the wheelchair.
2. Slide calfpad up or down until desired position is obtained.
NOTE: If one of the top two calfpad adjustment positions is being used, the legrest will need to be
raised to avoid interference with the front stabilizers while going over obstacles or going up and
down ramps. Refer to Raising/Lowering Elevating Legrests on page 40.
3. Turn the calfpad toward the inside of the wheelchair.
FIGURE 7.6
Raising/Lowering Elevating Legrests and/or Adjusting Calfpads
Adjusting/Replacing Telescoping Front Rigging Support
NOTE: For this procedure, refer to FIGURE 7.7 on page 42.
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not
interfere with the caster wheel rotation.
1. Lift up on the crossbraces until they release from the H-blocks on the wheelchair
frame.
2. Remove the long socket bolt and locknut that secure the front H-block and spacer to
the wheelchair frame and telescoping front rigging support.
3. Remove the front, and rear short socket bolts and the two locknuts that secure
telescoping front rigging support to wheelchair.
Release Lever
Top Two Calfpad
Adjustment Positions
Calfpad Rotated for Height
Adjustment
Calfpad
