SECTION 7—FRONT RIGGINGS
R51™and R51LXP
42
Part No. 1106645
4. Perform one of the following:
• Adjusting:
NOTE: Telescoping front rigging supports may be extended up to 2-inches from the wheelchair
frame in 1-inch increments. This adjustment does not effect seat depth.
i. Position the telescoping front rigging support to the desired depth.
• Replacing:
i. Remove the existing telescoping front rigging support from the wheelchair
frame.
ii. Insert the new telescoping front rigging support into the wheelchair frame.
iii. Position the telescoping front rigging support to the desired depth.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
5. Using the front and rear socket bolts and two locknuts, secure the telescoping front
rigging support to the wheelchair frame as shown in FIGURE 7.7.
6. Using the long socket bolt and locknut, secure the H-block and spacer to the
wheelchair frame and the telescoping front rigging support as shown in FIGURE 7.7.
7. Snap crossbraces into H-blocks. Wiggle crossbraces to make sure they are secured in
the H-blocks.
8. If necessary, repeat STEPS 1-8 on remaining telescoping front rigging support.
FIGURE 7.7
Adjusting/Replacing Telescoping Front Rigging Support
Wheelchair Frame
Rear Socket Bolt
Long Socket Bolt
Front Socket Bolt
Spacer
H-Block
Locknuts
Do Not Use With
Front Socket Bolt
Telescoping Front
Rigging Support
2-inch
0-inch
1-inch
Front Socket Bolt Positions
(Depth)
