intrepid Intrepid 6140 Director, Инструкция по установке и обслуживанию

Страница: 163 / 430

Maintenance Analysis Procedures
3-43
Maintenence Analysis Procedures
A port card failure is indicated. Go to step 21 .
19
A port failed a loopback test. Reset the failed port.
a. At the EFCM Basic Edition interface:
1. Select Ports and Reset from the Maintenance menu at any
view. The
Reset View
displays.
2. If necessary, use the vertical scroll bar to display the
information row for the port.
3. Select (click) the check box in the
Reset
column.
4. Click OK . The port resets.
b. At the Element Manager:
1. At the Hardware View , right-click the port. A pop-up menu
appears.
2. Select Reset Port . The message This operation will cause
a link reset to be sent to the attached device displays.
3. Click OK . The port resets.
c. Perform an external loopback test for the reset port ( Performing
Loopback Tests
on page 4-21).
Was the maintenance action successful?
NO YES
↓
The product port is operational. Exit MAP.
20
A port failed and the optical transceiver must be replaced ( RRP:
Optical Transceiver (SFP and XFP) on page 5-17).
• The procedure is concurrent and performed while the product is
operational.
• Verify the location of the failed port. Figure 3-2 and Figure 3-3
show UPM card numbers (0 through 34), port numbers (00
through 139), and bolded logical port addresses.