intrepid Intrepid 6140 Director, Инструкция по установке и обслуживанию

Страница: 257 / 430

5
RRP: Filler Panel (UPM and XPM)
5-21
Removal and Replacement Procedures (RRPs)
RRP: Filler Panel (UPM and XPM)
Use the following procedures to remove or replace a UPM or XPM
filler panel. Filler panels cover and protect unused port card slots in the
director chassis. A list of tools required is provided.
Tools Required The following tools are required to perform these procedures.
• Door key with 5/16-inch socket (provided with the FC-512
Fabricenter equipment cabinet).
• Torque tool and hex adapter (provided with the director).
Removal
To remove a filler panel:
1. To remove a front-mounted FRU, perform one of the following:
— If the director is installed in a McDATA-supplied FC-512
Fabricenter equipment cabinet, insert the 5/16" door tool into
the socket hole at the right top of the front door. Turn the tool
counter-clockwise to unlock and open the door.
— If the director is installed in a customer-supplied equipment
cabinet, unlock and open the cabinet front door as directed by
the customer representative.
2. To remove a rear-mounted FRU, remove the RFI shield.
3. Identify the filler panel to be removed.
4. The filler panel is secured to the director chassis with two captive
Allen screws. Both screws are spring-loaded to lock the filler
panel in place.
5. Insert the torque tool into each locking Allen screw ( Figure 5-5 ).
Turn each screw counter-clockwise until the spring releases and
the tool turns freely.
6. Pull the filler panel out and remove it from the director chassis.