intrepid Intrepid 6140 Director, Инструкция по установке и обслуживанию

Страница: 232 / 430

4
4-52
Intrepid® 6140 Director Installation and Service Manual
Repair Information
5. Click Reset to start the reset and close the dialog box.
6. The IP address resets to the defaults of 10.1.1.10.
— If the configured IP address (prior to reset) was the same as
the default, the director-to-management server Ethernet link is
not affected and the procedure is complete.
— If the configured IP address (prior to reset) was not the same
as the default, the director-to-management server Ethernet
link drops and server communication is lost. Continue to the
next step.
7. To change the switch IP address and restart the management
server session, go to step 8 . To restart a management server
session using the default IP address of 10.1.1.10:
a. Close the Element Manager application and return to the SAN
management application.
b. A grey square with a yellow exclamation mark appears
adjacent to the icon representing the reset director, indicating
that the director is not communicating with the management
server.
c. At the SAN management application, select Setup from the
Discover menu. The Discover Setup dialog box displays
(
Figure 4-20 ).
Figure 4-20
Discover Setup Dialog Box
d. Select (highlight) the entry representing the reset director in
the Available Addresses window and click Edit. The Address
Properties dialog box displays (
Figure 4-21 ).