IntesisBox DK-RC-KNX-1i, Руководство пользователя

Страница: 48 / 66

IntesisBox
®
KNX - Daikin A.C. (SKY & VRV line)
User's manual r1.0 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox ® is a registered trademark of Intesis Software SL
URL
Email
tel http://www.intesis.com
info@intesis.com
+34 938047134
48 / 66
 When “On” is selected, the binary input will send a telegram with a “1” value
after a bus recovery. Also a new parameter will appear (see below).
 When “Off” is selected, the binary input will send a telegram with a “0” value
after a bus recovery. Also a new parameter will appear (see below).
Figure 4.40 Parameter detail

Sending delay after a bus recovery (seconds)
This parameter lets configure a delay (in seconds) that will be applied after a
bus recovery and, after which, a telegram will be sent.

Value on rising edge
This parameter lets select the value that the Binary Input “x” will send on a rising edge
(contact activated).
 When “On” is selected, the binary input will always send telegrams with a “1”
value.
 When “Off” is selected, the binary input will always send telegrams with a “0”
value.
 When “Toggle (On/Off)” is selected, the binary input will send a “1” value
after a “0” value and viceversa.
 When “No action” is selected, the binary input will not perform any action.

Value on falling edge
This parameter lets select the value that the Binary Input “x” will send on a falling
edge (contact deactivated).
 When “On” is selected, the binary input will always send telegrams with a “1”
value.
 When “Off” is selected, the binary input will always send telegrams with a “0”
value.
 When “Toggle (On/Off)” is selected, the binary input will send a “1” value
after a “0” value and viceversa.
 When “No action” is selected, the binary input will not perform any action.

Cyclical sending