IntesisBox DK-RC-KNX-1i, Руководство пользователя

Страница: 14 / 66

IntesisBox
®
KNX - Daikin A.C. (SKY & VRV line)
User's manual r1.0 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox ® is a registered trademark of Intesis Software SL
URL
Email
tel http://www.intesis.com
info@intesis.com
+34 938047134
14 / 66
o
If set to “yes” the Status_ Operation Hour Counter object will appear.
 This object can be read and sends its status every time an hour is counted. The
gateway keeps that count in memory and the status is sent also after a KNX
bus reset/failure. Although this object is marked as a
Status_ object it also can
be written to update the counter when needed. To reset the counter should be
written a
“0” value.
Important: This object comes by default without the write (W) flag activated.
If is necessary to write on it, this flag must be activated.
Important: This object will also return its status, every time a value is written,
only if it’s different from the existing one.
Important: If the stored value is 0 hours, the gateway will not send the status
to KNX.
4.1.7
Enable object “Error Code [2byte]”
This parameter shows/hides the
Status_ Error Code communication object which shows the
indoor unit errors, if occurred, in numeric format.
o
If set to “no” the object will not be shown.
o
If set to “yes” the Status_ Error Code [2byte] object will appear.
 This object can be read and also sends the indoor unit error, if occurred, in
numeric format. If a
“0” value is shown that means no error.
4.1.8
Enable object “Error Text Code [14byte]”
This parameter shows/hides the
Status_ Error Text Code communication object which shows
the indoor unit errors, if occurred, in text format.
o
If set to “no” the object will not be shown.
o
If set to “yes” the Status_ Error Text Code object will appear.
 This object can be read and also sends the indoor unit error, if occurred, in text
format. The errors shown have the same format as at the remote controller and
at the error list from the indoor unit manufacturer. If the object’s value is empty
that means no error.
4.2 Mode Configuration dialog