Interlogix FlexZone Series, Руководство по эксплуатации продукта

Страница: 81 / 104

Chapter 3: Calibration and setup
FlexZone™ Product Guide
75
Local control mode
In local control mode, the two Aux inputs are used to activate electronic self-tests
(AUX1 = A-side, AUX2 = B-side). To activate the self-test function, close a
momentary switch across the input. You must close the momentary switch for the
time specified in the Filter Window. Leave the AUX inputs open if you do not
want to use the self-test function.
Remote control mode
In Remote control mode, the two Aux inputs serve as auxiliary device inputs to
the host Security Management System (SMS). The inputs are available for
reporting the status of other security devices. The processor reports any change
of an input’s state to the SMS via the Silver Network Manager. Table 2 below
includes the selectable Remote Control input wiring configurations, and Table 3
on page 75 includes the selectable supervision resistor values.
Table 2: Selectable input configurations
Input option UCM selection Alarm relay Supervision
relay
R1 R2
Unsupervised
A
NO --- --- ---
Single resistor
supervision
1 A
S
NO NC 5.1 k ---
Dual resistor
supervision
1
2
A
S
NO NO/NC 4.3 k 820
Unsupervised
A
NC --- --- ---
Single resistor
supervision
1
A
S
NC NO 5.1 k ---
Dual resistor
supervision
1
2
A
S
NC NO/NC 5.1 k 820
Table 3: Selectable resistor values
R1 values (single resistor
supervision) R1 values (double resistor
supervision) R2 values (double resistor
supervision)
820 1.1 k 820
1 k 2.2 k 1.1 k
1.1 k 4.3 k 2.2 k