45
I.Indoor phone digit
In the menu of P8, input [3] + [#] , the LCD will shows as P9.
The right number shows the current indoor phone digit. Input the
new number (2~4), and press [ # ] button to confirm.
[Note] You should choose the indoor phone digit first,
then you
can proceed with the indoor phone number setting.
1. Indoor phone setting
In the menu of P3, input
[1]+[#]，
, the LCD will shows as P8, the
information of indoor phone can be set here.
(8)
(9)
Then proceed with indoor phone information input
，
there are two input modes
：
Single input mode
and matrix input mode
，
user can choose what they need.
II. Single input mode
In the menu of P8, input [0]+[#]
,
the LCD will show as P10.
Input the indoor phone No., distributor No., port No., and ring No.
in turn.
◆
Indoor phone No: 2~4 digit No.
（
Digit is depended on the last
indoor phone digit
）
e.g.
0101
◆
Distributor No
：
Input the distributor No. of indoor phone, valid
scope
：
001~254
e.g.001
◆
Port No.
：
Input distributor port No. connecting to indoor phone
valid scope
：
1~4
e.g.
1
◆
Ring
：
This system offers 3 types of ring for user to choose
，
input ring No.(1~3)
e.g.
3
After finish, the LCD shows as P11, input next indoor phone No.
or press [*] to back to P8.
[Note] 1. Ringing is only heard when indoor phone is called.
2. When system’
s ring is chord, there are 3 types of rings for
chosen, otherwise it is always “Dingdong”ring when choose 1-3.
(10)
(11)
(12)
(13)
(15)
(14)
In the menu of P8, input [1]+[#], the LCD will show as P12.
◆
Start No: Input the start indoor phone No. e.g.
0101
◆
End No: Input the last indoor phone No.
e.g.
0704
◆
Ring Type: Input ring number (1~3)
e.g.
1
◆
Password
：
Input resident password
e.g.
1234
After finish, the LCD shows as P13, press [*] to back to P8.
[Note] The original password is 1-2-3-4. You can refer to “Appendix 2”
→
”Change password” to change it.
III. matrix input mode
[Note] This mode is only suitable for buildings with matrix
structure
，
if every floor has different quantity of apartment,
then should choose single input mode.
IV. Indoor phone data upload
In the menu of P8, input [4]+[#]. The LCD will show as P14,
finally the LCD shows the upload result which is P15
Press [*] back to P8.
[Note] This function is for upload indoor phone data saved in door
station to gate-way when in network.
10
Door station extender diagram
1. Door station should be set for busy mode: Switch off power, press the button 1 on door station then switch on power. After this, when
one door station is used, other door station will show “system busy”, this can prevent system conflicts.
2. When setting ports for door station and gate-way, the ports No. should be set as the following sequence.
Door station No.
Gate way port No.
door station
0001
1
accessory door station 1
0002
2
accessory door station 2
0003
3
…
…
…
accessory door station7
0008
8