Intellian v240M, Инструкция по установке и эксплуатации

Страница: 85 / 177

85
OPERATION INSTRUCTION
Setup Block Zone
Up to 5 block or radiation hazard zones can be programmed with relative azimuth
and elevation sectors.
Block zone MODE
Block zone range
Block zone 1
Antenna MODE
Setup mode
S E T U P M O D E ?
4
Y E S N O
1. Press the LEFT arrow key to move the cursor to YES and press the OK key to enter SETUP
mode.
4
+ A N T E N N A + S A T E L L I T E
+ S Y S T E M + I N S T A L L A T I O N
2. Press the OK key to enter the ANTENNA menu.
4
+ B L O C K Z O N E + D I A G N O S I S
3. Press the RIGHT arrow key to move cursor to BLOCK ZONE and press the OK key to enter
it. Up to 5 block zones are allowed to be programmed.
Z O N E 1 B L O C K
O N
4
A Z . 1 S T A R T A Z . 1 E N D E L . 1 L I M I T
0 0 0 0 0 0 9 0
4. Set ZONE 1 BLOCK
Press the UP and DOWN arrow keys to select “ON” to setup the block zone for ZONE 1.
Press the OK key to use ZONE 1 BLOCK and set the zone 1 block range.
Press the BACK key to select the parameter you wish to edit and press the BACK key again
to save or abort and return to the main display.
Set the AZ.1 START, AZ.1 END and EL.1 LIMIT while ZONE 1 BLOCK is ON.
This is the clockwise of the two points. AZ.1 START is where the relative azimuth starts and
AZ.1 END is where the relative azimuth ends (Range: 0- 360°). The EL.1 Limit is where the
elevation starts (Range 0- 90°).
Press the LEFT and RIGHT arrow keys until the desired character is underscored (selected).
Press the UP and DOWN arrow keys to increase and decrease the selected character.
Or Press the NUMBER keys to set the desired value directly. Press the OK key to set the
parameter. Press the BACK key to select the parameter you wish to edit and press the BACK
key again to save or abort and return to the main display.