Intel M70KLP Series, Руководство по обслуживанию

Страница: 16 / 109

Intel® Server System M70KLP Family Service Guide
14
Figure 2. System Top Cover Removal
1. Using a phillips screw driver, rotate the latch lock ¼ tur n to the “Unlock” position (see Letter A).
2. Lift the latch to its full open position. The top cover will slide back (see Letter B).
3. Lift the back edge of the top cover, then slide the top cover back and away from the chassis
(see Letter C).
2.1.2 Air Duct Removal
Note: Instructions will be identical regardless of air duct type installed (Standard or Low Profile)
The air duct is held in place using a lock bar that must be removed prior to removing the air duct. Integrated
within the lock bar assembly is a chassis intrusion switch that is cabled to the server board. This cable must
be carefully disconnected from the server board before removing the lock bar.
Figure 3. Chassis Intrusion Switch Cable Connection on Server Board
1. Located below the back edge of the air duct, unlatch and disconnect the white two-wire chassis
intrusion switch cable from the server board (see
Figure 3 ).
• DO NOT pull on the wires to disconnect the cable . Doing so may detach the wires from the
connector.
2. Pull-up