Innovx FastSwitch, Руководство по установке и эксплуатации

Страница: 54 / 62

Application Guidelines General Application Information
A-2 Innovx FastSwitch Ethernet Switch 200R204-000
Installation and Operation Manual Issue 2
Default Configurations
The FastSwitch is shipped from the factory with the ordered Default Profile that most suits the
customer application. The Profile establishes default values for most configurable settings required
by the FastSwitch.
Table A-1 describes Default Configuration Profile #1. Your factory defaults may
vary, depending on which profile was ordered with your unit.
Users can change values from the default setting via Supv or Admin access to the CLI or the web
interface. The Default Profile can be reloaded back into a FastSwitch whenever a “clean baseline”
is desirable prior to downloading a batch file configuration. To accomplish this, type
default
all
at the command prompt, or add the
# default all
command uncommented at the start
of your configuration batch file. You may need to reboot the unit.
Table A-1 Default Configuration
Setting Default
System Prompt ES-09 or ES-18
Inactivity Timer 900 seconds
HTTP Service Disabled
SNMP Service Disabled
Mgt Configuration Disabled
Port 1 through Port n Enabled
Auto-negotiate Enabled
Speed 10 Mbps
Mode Half Duplex
FDX Flow Control On
MDIX Not Forced
Auto-MDIX Auto
Port Mirroring Disabled
Auto-Stats (Future Use)
Virtual LAN
(Future Use)
SNMP Configuration
Community public ro en
Name “YOUR SYSTEM NAME”
Contact “YOUR SYSTEM CONTACT”
Location “YOUR SYSTEM LOCATION”
User Accounts Configuration admin
supervisor
gdc
Console (craft port) Authentication
Disabled
Auto Reboot Disabled
To enable, uncomment the batch file
line:
# reboot
Authentication Disabled (See Chapter 5 for details.)
Netowrk Time Disabled (See Chapter 5 for details.)