Infinova V3070-8 Series, Руководство пользователя

Страница: 31 / 90

23
for you to use the special keyboard to control the device. PTZ
matrix is to connect to the peripheral matrix control.
z
Baud rate: You can select proper baud rate.
z
Data bit: You can select proper data bit. The value ranges
from 5 to 8.
z
Stop bit: There are three values: 1/1.5/2.
z
Parity: there are five choices: none/odd/even/space mark.
System default setup is:
z
Function: Console
z
Baud rate:115200
z
Data bit:8
z
Stop bit:1
z
Parity: None
After completing all the setups please click save button, system
goes back to the previous menu.
Figure 5-31
5.6.5 Network
Here is for you to input network information. See Figure 5-32.
z
IP Version: There are two options: IPv4 and IPv6. Right now,
system supports these two IP address format and you can
access via them.
z
MAC address: The host in the LAN can get a unique MAC
address. It is for you to access in the LAN. It is read-only.
z
IP address: Here you can use up/down button (
ST
) or
input the corresponding number to input IP address. Then
you can set the corresponding subnet mask the default
gateway.
z
Subnet prefix: The input value ranges from 0 to 128. It is
to mark a specified network MAC address. Usually it
includes an organization of multiple-level.
z
Default gateway: Here you can input the default gateway.
Please note system needs to check the validity of all IPv6
addresses. The IP address and the default gateway shall be
in the same IP section. That is to say, the specified length of
the subnet prefix shall have the same string.
z
DHCP: It is to auto search IP. When enable DHCP
function, you can not modify IP/Subnet mask /Gateway.
These values are from DHCP function. If you have not
enabled DHCP function, IP/Subnet mask/Gateway display
as zero. You need to disable DHCP function to view
current IP information. Besides, when PPPoE is operating,
you can not modify IP/Subnet mask /Gateway.
z
TCP port: Default value is 37777. You can change if
necessary.
z
UDP port: Default value is 37778. You can change if
necessary.
z
HTTP port: Default value is 80.
z
RTSP port: Default value is 554.
Important: System needs to reboot after you changed and
saved any setup of the above four ports. Please make sure
the port values here do not conflict.
z
Max connection: system support maximal 20 users. 0
means there is no connection limit.
z
MTU: It is to set MTU value of the network adapter. The
value ranges from 1280-7200 bytes. The default setup is
1500 bytes. Please note MTU modification may result in
network adapter reboot and network becomes off. That is
to say, MTU modification can affect current network
service. System may pop up dialog box for you to confirm
setup when you want to change MTU setup. Click OK
button to confirm current reboot, or you can click Cancel
button to terminate current modification. Before the
modification, you can check the MTU of the gateway; the
MTU of the NVR shall be the same as or is lower than the
MTU of the gateway. In this way, you can reduce packets
and enhance network transmission efficiency.
The following MTU value is for reference only.
—
1500: Ethernet information packet max value and it is also
the default value. It is the typical setup when there is no