Infinity 890 BF, Руководство пользователя

Страница: 5 / 32

LT 6541 (Iss 4 07/14) 5
INFINITY 890 BF Users Instructions
SECTION TWO Introduction

The INFINITY 890 BF is an inset room sealed decorative fuel-effect gas appliance designed for
use in locations that do not have a conventional chimney. The appliance must be installed against
an outside wall because the air to support combustion is taken from the outside and the products
of combustion are expelled to the outside.

The appliance incorporates a safety device in the form of a FLAME SUPERVISION DEVICE,
which constantly monitors the flame and will cause the gas to be switched off if the flames are
extinguished for any reason.
THIS DEVICE MUST NOT BE OVERRIDDEN. If this situation
occurs on a regular basis have the appliance checked by a qualified engineer. The problem may
be due to a blocked or restricted flue.

Before removing the, trim, glass shapes for cleaning the fire should be turned off, and left to cool
down.

NOTE: In use some discoloration of the components will take place in the combustion box, this is
normal, but can be kept to a minimum if the shapes are placed correctly (i.e. after cleaning). See
Section 4.

As with all heating appliances certain areas (Working Surfaces) become very hot when the
appliance is in use.
SECTION THREE Operation
To light the appliance using the remote hand set:
a. Point the remote control hand set in the direction of
the appliance and press the button. Continue to
hold the button for approximately 2 seconds and
release. When released a bleep should be and heard
the appliance will automatically go through the ignition
sequence and the pilot should ignite. Once the pilot is
alight the appliance will automatically go to the high
setting (approximately 20-25sec).
b. If the ignitor stops sparking and the pilot fails to light
press the button for at least 2 seconds and
release, again a bleep should be heard. Then repeat
the lighting procedure.
* See note on page 7
c. With the appliance lit, by pressing key the operational mode is switched from manual to Room
thermostat setting and vice versa. When Room thermostat mode is active, the display shows the
set temperature value and the “AUTO” icon will appear on the LCD display. By using the
arrow
key the desired room temperature can be set. When manual mode is active, the display shows
the “MAN” icon plus the flame icon and a five level bar icon setting. By pressing the
arrow key,
the flame picture can be adjusted at five stages between high and low flame. If level 5 is currently
active, the icon max below the flame icon will appear.
d. To switch off the appliance press the button for at least 2 seconds and on releasing the button
the appliance will bleep and then shut off. For pilot setting press the for 1 second and release.
The pilot symbol will appear on the LCD display.Pressing the button will bring the fire back
onto main flame.