Infinity 890 BF, Руководство пользователя

Страница: 21 / 32

LT 6541 (Iss 4 07/14) 21
INFINITY 890 BF Installation Instructions
SECTION TEN CONNECTING THE GAS SUPPLY
TURN OFF ANY GAS APPLIANCES THAT ARE FED BY THE METER AND ISOLATE THE GAS
SUPPLY BY TURNING OFF AT THE METER.

Connections may be made in 8mm-dia pipe by a concealed connection from the left hand rear of
the appliance with the grommet provided.

An isolating cock is fitted in the supply feed to the fire to facilitate servicing. It may be rotated for
right gas connection.

When a concealed gas fitting from the rear is required it is necessary to route the pipe to the left
side of the unit, taking into account the requirements of BS 6891 1988 dealing with enclosed
pipes.

When installing the firebox into a cavity wall, any part of the installation pipe work installed in the
void open to the cavity wall must be enclosed in a gas tight sleeve. It must be sealed at the point
at which the sleeved installation pipe enters the fire (The Gas Safety (Installation and Use)
Regulations Certificate of exemption number 1 of 1996).
Where the pipe enters the fire the outer
sleeve must be sealed to the grommet and the pipe must be sealed to its outer sleeve using
suitable mastic.
CHECKING GAS SOUNDNESS

Complete gas connection to the fire and check for gas soundness in accordance with current
codes of practice.
SECTION TEN Assemble the Appliance

Position the shaped components as described in section four of this manual, it is important that
the shapes are positioned exactly as described to ensure the correct operation of the appliance.
Badly positioned shapes may result in the gas flame being driven forward onto the glass and
permanently marking it.

Position the glass frame assembly over the top glass frame adjustment bracket so that it locks
into place, it may be necessary to adjust the bracket with the 5 castle nuts to obtain a good seal
against the glass panel. Ensure that the four studs go through the slots at the bottom of the glass
frame.

Taking great care, tighten the four nuts at the bottom until the glass creates a good seal and
adjust the five nuts on the top adjustment bracket if necessary.

Ensure that the glass compresses the seal on all four sides.

Load 6 off of the 1.5 v “C” batteries into the holder provided and insert into heat shield pouch.
Locate the battery holder within the fire on the bottom right hand side and as far forward to the
front of the fire box .

Position the fascia so that its central over the
top flange of the combustion box fitting back
against the firebox using the magnets
provided.
BATTERY POSITION