Infinity 890 BF, Руководство пользователя

Страница: 17 / 32

LT 6541 (Iss 4 07/14) 17
INFINITY 890 BF Installation Instructions
SECTION NINE To Install the Appliance
INSTALLING THE APPLIANCE INTO CAVITY WALL. (
When installing in a timber framed
dwelling reference must be made to the specific installation requirements stated later in this Section
‘Installing The Appliance In Timber Framed Dwelling’
) .

Ensure it is a suitable outside wall constructed of non-combustible materials and that the flue
position meets the requirements previously described in
Section 8 .

Mark a horizontal line on the wall at the intended appliance base height 150mm min from
combustible surface or 50mm min from non combustible hearth.

Mark a vertical line on the wall at the intended centre of the appliance up from the horizontal line
for a height of 430mm.

If insetting into the wall mark the position for a lintel above the top horizontal line.

Mark a short horizontal line so it crosses the centre line at 75mm above hearth level line. This is
the centre point for the Air Duct pipe hole.

Mark a short horizontal line so it crosses the centre line at 355mm above hearth level line. This is
the centre point for the Flue Duct pipe hole.

Using a long masonry drill, make two pilot holes completely through the wall. Ensure the holes are
drilled accurately at the centres and square to the wall both horizontally and vertically at the cross
points previously marked.

If insetting into the wall proceed as follows: Cut out the brickwork of the inner skin of the cavity
wall for the lintel, and fix the lintel.

Cut out the brickwork under the lintel, between the two outside vertical lines into the cavity.
Ensure the cutout width is square and try the appliance into the opening.