Infineon CY7110, Руководство пользователя

Страница: 9 / 67

User Guide 9 of 67 002-32601 Rev. *C
2021-12-02
EZ- PD™ PMG1 MCU prototyping kits guide
CY7110/CY7111/CY7112/CY7113
Introduction
•
There are two push buttons on the CY7110 kit and three push buttons on the CY7111/CY7112/CY7113 kits.
See
Table 3 for the details
Table 3 Prototyping kit – push buttons
Button Description
KitProg3 mode (SW1) The mode button is used to put the KitProg3 into bootloader mode. See the
KitProg3 user guide
[6] for details.
User switch (SW2) This button can be used to provide input to the EZ- PD™ PMG1 MCU. This
button pulls the pin to the ground, by default.
Reset switch (SW3) 2 This button is used to reset the EZ- PD™ PMG1 MCU. It connects the EZ- PD™
PMG1 MCU reset (XRES) pin to the ground.
•
DC_OUT terminal block to connect the output of the load switch to an external circuit through wires. The
Type-C contract voltage is available at the DC_OUT terminal block when a successful PD contract is
established
•
An onboard LDO regulates the Type-C voltage to 3.3 V and powers the user LED. This is available as a power
output to power external modules if required
•
All GPIOs and alternate power supply pins are routed to I/O headers placed on the sides of the prototyping
kit. The headers are compatible with a 2.54-mm standard breadboard to extend the kit functionality.
Table
4 lists the pins count of I/O headers in all EZ- PD™ PMG1 kits
Table 4 I/O header pin count
Kit MPN Number of I/O header pins
CY7110 15 + 15
CY7111 18 + 18
CY7112 18 + 18
CY7113 20 + 20
1.3.2 Power selection jumper
The power selection jumper (J5) is a three-pin selection header used to switch between operational mode and
programming mode.
Figure 6
Power selection jumper
2
Not applicable for the CY7110 prototyping kit because the EZ- PD™ PMG1 -S0 MCU does not support XRES.