User Guide
60 of 67
002-32601 Rev. *C
2021-12-02
EZ-
PD™ PMG1 MCU prototyping kits guide
CY7110/CY7111/CY7112/CY7113
Application development on CY711x kits using ModusToolbox™ software
Do the following to program or debug the CY7111/CY7112/CY7113 kit using J-Link probe from ModusToolbox
™
software:
1.
Open the Eclipse IDE for ModusToolbox™ software
on the host PC and select the
PMG1
project. For details,
see the Eclipse IDE for
ModusToolbox™ software user guide
2.
Place the jumper shunt on pins 1
–
2 of the power section jumper (
J5
) to configure the kit in operational
mode.
3.
Connect the USB PD sink port to the USB PD source to activate the onboard LDO, load switch, and user LED.
Ensure that LED4 (power LED) glows green.
4.
Connect J-Link debugger to prototyping kit through 10-pin SWD connector, and use a 9-pin Cortex®-M
adapter.
5.
In case you want to program the MCU, click
<Application name> Program (J-Link)
from the
Launches
section.
6.
In case you want to debug the application, click
<Application name> Debug (J-Link)
from the
Launches
section. The IDE will switch to debugging mode and will halt at the first line of the main () function. This
indicates that the application is ready for debugging.
Figure 56
Program/debug using J-Link debugger probes
