User Guide
41 of 67
002-32601 Rev. *C
2021-12-02
EZ-
PD™ PMG1 MCU prototyping kits guide
CY7110/CY7111/CY7112/CY7113
Kit operation
for troubleshooting information.
Note:
The default USB PD sink firmware can be replaced by new firmware as part of the application
development process. See
Application development on CY711x kits using ModusToolbox
for more details.
The CY7113 EZ-
PD™ PMG1
-S3 MCU
prototyping kit firmware support CAPSENSE™ se
nsing in addition to USB PD
sink operation. The procedure for exercising CAPSENSE™ operation is
as follows:
1.
The initial setup is the same to run USB PD sink firmware. Follow Steps 1 to 5.
2.
The CAPSENSE™
buttons are exercised by touching each button and observing the corresponding
feedback LED behavior. When BTN1 is touched, LED5 will turn ON and for BTN2, LED6 will turn ON. The
LEDs turn OFF when corresponding sensors are not touched.
3.
For testing the
CAPSENSE™ slider, place
your finger on SLD1 and swipe from left to right. The feedback
LEDs will glow in a sequence (LED7
→
LED8
→
LED9
→
LED10
→
LED11). Then swipe from right to left, and
LEDs will glow in reverse sequence (LED11
→
LED10
→
LED9
→
LED8
→
LED7).
Figure 35
CAPSENSE™ buttons and slider
