Industrex M43ic, Инструкция по эксплуатации

Страница: 48 / 51

Industrex M43ic / M43icN
page 42 01/2013 TK
correction
A) Adapt the bath tempera-
ture to the recommended
process or change
chemistry.
B) Decrease transport speed.
C) Increase exposure time.
D) Fill bath to the right level.
Check Replenish-tanks.
E) Replenish or change
chemistry.
F) Carefully clean the tank
and replace chemistry.
G) Adjust setting or repair
faults.
A) Decrease developer
temperature.
B) Increase processing time.
C) Reduce exposure time.
D) Add starter according to
instructions.
A) Seal off light leak.
B) Check filter, wattage and
distance from the dark-
room lamp to the
processor.
C) Check date of maturity.
A) Only use material suitable
for roller processing.
B) Replenish or change
chemistry.
C) Check level of the
replenishment containers.
Fill up the bath to the
required level.
D) Check the pump motor.
Eventually repalce it.
possible cause
A) Bath temp is too low
B) Transport speed is too
high.
C) Exposure time is too
short.
D) Bath level ist too deep (no
heating and circulation)
E) Developer exhausted
F) Fixer getting into developer
(Dev becomes cloudy)
G) Exposure settings are
incorrect or machine is
faulty.
A) Developer termperature is
too high.
B) Processing time is too slow.
C) Exposure time is too long.
D) After new chemistry: starter
is missing.
A) Light leak in darkroom or
cassette
B) Incorrect darkroom light
C) Material is outdated.
A) Unsuitable hand processing
material is used.
B) Fixer is exhausted.
C) Level of fixer bath has
dropped (Temperature
safety fuse has been
activated).
D) Circulation pumps have
failed.
problem
19. PAPER OR FILM
TOO LIGHT
20. PAPER OR FILM
TOO DARK
21. PAPER OR FILM
IS FOGGED
22. PAPER OR FILM
HAS YELLOW-
GREEN SURFACE