Industrex M43ic, Инструкция по эксплуатации

Страница: 29 / 51

Industrex M43ic / M43icN
page 23 01/2013 TK
The filmprocessor is equipped with an anti-oxidation and a anti-crystallization cycle.
That means, when in standby, the processor will start the transport of the rollers and the
wash on regular intervals in order to prevent crystallization on the rollers (Anti-
crystallization). The anti-oxidation cycle activat, in free programmable time intervals,
replenishment cycles. This will prevent oxidation of the the chemistry.
During such a cleaning cycle, the display
will look like this.
During such a cycle the filmprocessor will accept
media. It's not necessary to wait to the end of
the cycle.
5.4 STANDBY OPTIONS
Feeder P- Speed:
0.0 cm/min
Film location:
- o - - II - o - -
Feeder Speed:
speed of the
feeder
Film location:
used to monitor the
films from the feeder
to the filmprocessor.
left side: loader
right side:
filmprocessor
-..... no film
o..... film
55% Done is the progress indicator. It means
55% of the developing process is complete.
When it reaches 100% , the machine will go to
standby.
T1=26,1ºC gives you the actually measured
temperature in the tank. The value in the brackets
is the programmed temperature. The same
indication is available for
tank 2 (T2) and for the dryer (T3).
Rep1 and Rep2 are the replenishment rates
for the current program.
Tank1 time is the time the media stays in tank 1 .
Dry to dry is the length of the complete
processing cycle (leading edge to heading edge).
Film Speed linear speed of the media inside
the filmprocessor.
Film Speed
XX.X cm/min
P1 Cleaning 30%
T1=32.4ºC (32.5)
only when a
Colenta AUTO
Loader is in use
Film Speed:
40,3 cm/min
P1 Cleaning 30%
T1=26,0°C (26,0)