Industrex M43ic, Инструкция по эксплуатации

Страница: 13 / 51

page 7 01/2013 TK
Industrex M43ic / M43icN
WARNING
CAUTION
1.1.6 Chemical hazards:
Corrosive liquids
WARNING:
CHEMICALS MAY IRRITATE EYES, LUNGS, SKIN AND DIGESTIVE TRACT
Eyes, skin and lungs may be irritated by photo chemicals.Before using photo
processing chemicals always read the Material Safety Data Sheets (
MSDS s)
for information about the hazards of the particular chemicals and how to use
them safely contact the chemicals manufacturer or dealer.
Wear safety goggles,protective gloves and
chemical aprons as indicated on Material
Safety Data Sheets ( MSDS s)when handling
chemicals.
CAUTION:
To avoid hazardous situations, keep floors and floor coverings
around the processor and associated drains clean and dry
at all times. Any accumulation of fluids outside the film processor
should be cleaned/removed immediately.
Ensure proper ventilation in the area where chemicals are prepared,
used or stored.
Drain tanks carefully,avoid splashing. Always drain the system thoroughly before
working on any of the external hose systems. Do not allow untrained personnel to
handle photo processing chemicals or to operate the film processor.
Chemical disposal
Waste from photographic processing normally contains diluted chemicals. These chemicals
should be collected and disposed in accordance with local environmental codes. Dumping
chemicals into a drain system could lead to a pollution problem. Contact your local water
treatment and sewer district authorities before disposing chemicals.
All plumbing must comply with local and national codes. The DRAIN must be made of
chemical resistant and non-corroding material. Use PVC or equivalent.
Exhaust,temperature and humidity
It is necessary to ensure proper ventilation in order to receive good processing results.
Make sure that the exhaust hose of the built-in exhaust fan is properly connected to the
exhaust air socket (Picture 1).
The built-in exhaust fan exhausts the fumes from the film processor.
These chemical fumes are corrosive. The top cover and the feed cover lid of the film
processor should be left slightly open over night (picture2).