Industrex M43ic, Инструкция по эксплуатации

Страница: 36 / 51

Industrex M43ic / M43icN
page 30 01/2013 TK
The software includes the following features:
1 - Automatic wash tank fill / automatic wash tank draining
2 - Automatic Developer and Fixer tank fill (see next page)
1 - Automatic wash tank fill / automatic wash tank draining
This feature ensures that the water level in the wash tank is at the normal level on
„start-up“ and then to drain automatically on shut down. This is accomplished by the use
of an additional level sensor in the wash tank to inform the filmprocessor controller on the
level of water in the tank and the use of an electrically controlled drain valve that will
remain „closed“ when the filmprocessor is in use and „open“ when the filmprocessor is
shut down. On morning „start-up“ the drain valve will be closed and the water „fill“
solenoid will open to allow water to pass into the wash tank until reaching normal
operating level. If the wash tank does not reach normal level within 20 minutes ( level
switch not activated) the electronics will assume that
there is a water supply problem and the error message „ can’t fill water“ will be
displayed. (see page 21 for further information).
The following instructions will activate or de-activate this feature:
Press the bottum
3
, use
6
to move the courser under "Options", press
7
, you
will see "Standby Refill" use again
6
to move the courser under "Refill", press
7
you will see:
Wash auto refill
1 (1-yes,0-no)
use
7
to set 1 or 0. After that procedure, use (3x)
8
to leave the menu, the
controller will ask you : Save Cancel choose save by using
7
.
5.13 ADDITIONAL FEATURES - REFILL WATER / CHEMISTRY