BOBCAT HD-SDI
Hardware User’s Manual
Imperx, Inc.
Rev. 1.4
6421 Congress Ave.
6/2/2014
Boca Raton, FL 33487
+1 (561) 989-0006
118 of 175
File
– loads the camera registers from a saved configuration file
Workspace
– updates the GUI with the current camera
workspace settings
Factory
– loads the camera registers with the original (factory)
settings.
User Space #1
– loads the camera registers with a saved camera
settings in the user space 1.
User Space #2
– loads the camera registers with a saved camera
settings in the user space 2.
Save To:
Saves the camera
registers to File, User Space #1 or User Space
#2. Factory Space is disabled for regular users and it is available
only for manufacturing technicians.
File
– saves the current camera settings to a configuration file
Factory Space
– saves the current camera settings to the camera
Factory space. This is restricted command and is disabled for
regular users.
User Space #1
– saves the current camera settings to the camera
User space 1.
User Space #2
– saves the current camera settings to the camera
User space 2.
Boot:
This menu selects the ‘Boot From’ source. Upon power up, the
camera will load its registers from the selected ‘Boot From’
source: Factory, User #1 or User #2. Bobcat camera will be
release with ‘Factory” Setting and user can save and boot
camera with their own configurable features.
DPM:
Defect Pixel Map – When selected, the DPM window will show
defected pixels location. The defective pixel map is stored in the
camera’s non-volatile memory and read out when running bad
pixel correction – Figure 5.4. Defected pixels are categorized as: