BOBCAT HD-SDI
Hardware User’s Manual
Imperx, Inc.
Rev. 1.4
6421 Congress Ave.
6/2/2014
Boca Raton, FL 33487
+1 (561) 989-0006
130 of 175
1.
Average – the average value of the image luminance will be
used in the comparison algorithm.
2.
Peak – the peak luminance value (maximum luminance
level) will be used in the comparison algorithm.
Exposure
– sets the maximum/minium exposure time, which
can be reached in the AEC mode in order to avoid motion smear
if a fast moving object is monitored. The user can select the
speed of convergence 1x (slow), 2x, 3x and 4x (fast).
Gain
– sets the maximum/minimum analog gain, which can be
reached in the AGC mode. The user can select the speed of
convergence 1x (slow), 2x, 3x and 4x (fast).
Current
– Provides live information about the current value of
the Exposure time, Gain and Luminance. The values will be
refreshed every time polling is done.
5.7.5.
Test Image
This window sets the test image mode. Several test images are available for
selection, including pattern superimposing over live image – Figure 5.14.
Ping:
Checks the serial connection status of the camera:
GREEN
– followed by a brief “OK”, indicates a successful
connection.
RED
– followed by and “ERR”, indicates no connection.
YELLOW
– “Ping” command was sent to the camera. A few
seconds after pinging, the indicator becomes gray and the
message disappears.
Test Mode
:
Test Patterns
– the camera can output eight test patterns:
1.
Off – test mode is off.
2.
Black – displays black image.
3.
Gray Image – displays a uniform dark gray image.
4.
White Image – displays a uniform white image.
5.
H Ramp – displays a stationary horizontal ramp image.
6.
V Ramp – displays a stationary vertical ramp image.
7.
H Ramp move – displays a moving horizontal ramp image.
8.
V Ramp move – displays a moving vertical ramp image.