BOBCAT HD-SDI
Hardware User’s Manual
Imperx, Inc.
Rev. 1.4
6421 Congress Ave.
6/2/2014
Boca Raton, FL 33487
+1 (561) 989-0006
126 of 175
Output:
The user can map each of the camera outputs to OUT1,
OUT2. 11 signals are available for mapping. For each input
the user can set the signal level to active “High” or active
“Low”.
1.
Exposure Start – a short pulse (2 us) indicating the
beginning of the camera exposure in trigger mode.
2.
Exposure End – a short pulse (2 us) indicating the end of
the camera exposure in trigger mode.
3.
Mid Exposure – a short pulse (2 us) indicating indicates
the middle of the camera exposure in trigger mode.
4.
Active Exposure Window – a signal indicating the
duration of the camera exposure in trigger mode.
5.
H-Sync – a short pulse (2 us) synchronized with the
camera line timing.
6.
V-Sync – a short pulse (2 us) synchronized with the
camera frame timing.
7.
Odd/Even Frame Flag – a signal indicating if the frame
is ODD or EVEN. It alternates every frame. When
“Active High” ODD is LOW.
8.
Trigger Pulse – maps the input trigger pulse to the
output with no delay (as is).
9.
Trigger Pulse Delayed – maps the input trigger pulse to
the output with delay set by the Exposure Delay
Register.
10.
Camera Ready – a signal indicating when the camera is
ready to accept the next trigger pulse.
11.
Pulse Generator – maps the internal pulse generator
waveform to the output.
12.
Strobe 1 – maps “Strobe One” signal to the
corresponding external output.
13.
Strobe 2 – maps “Strobe Two” signal to the
corresponding external output.
14.
Deselect – no signal is mapped.