6
GB
| Operating Instructions
1) Distance piece
4. Fit the guide bar to the power unit, and then push the
guide bar toward the clutch (Figure 3).
2) Guide bar
5.
Gear the chain to the sprocket and, while fitting the
saw chain around the guide bar.
NOTE
Pay attention to the correct direction of the saw chain.
6. Adjust the position of chain tensioner nail, and then
insert the tensioner nail in the lower hole of the guide
bar. Mount the clutch cover to the power unit and
fasten the mounting nut to finger tightness. While
holding up the tip of the bar, adjust the chain tension
by turning the tensioner screw until the tie straps just
touch the bottom side of the bar rail.
5. Installing guide bar and saw chain
A standard saw unit package contains the items as
shown below:
(1) Power unit (2) Saw chain
(3) Guide bar (4) Guide bar scabbard
(5) Plug wrench (6) File
Open the box and install the guide bar and the saw chain
on the power unit as follows.
WARNING
The saw chain has very sharp edges. Use protective
gloves for safety.
1. Pull the guard towards the front handle to check that
the chain brake is not on.
2. Loosen the nut and remove the clutch cover.
(Figure 1).
1) Nut
2) Clutch cover
3) Spiked bumper 4)
Protection cap
IMPORTANT
The Spiked bumper belongs to the chain saw.
Remove protection cap
(Figure 1).
3.
Remove the spacer from chain saw (Figure 2).
