SmartPLC SafeLine with PROFIBUS slave interface
138
8
Setup
Content
Install device .................................................................................................................................... 138
Connect the device to the periphery.................................................................................................. 138
Install devices on the local I/O interface ............................................................................................ 139
Start screen 'Basic settings' .............................................................................................................. 140
Notes on the firmware update ........................................................................................................... 142
Connect and address AS-i slaves ..................................................................................................... 142
Set the Profibus interface .................................................................................................................. 143
Setup of the configuration interface ................................................................................................. 143
Replace standard AS-i slave ............................................................................................................. 144
Replace safe AS-i slave .................................................................................................................... 144
41644
This section provides information for setting up the device following mounting, electrical installation
and connection to AS-i network components.
Observe the notes on mounting and electrical connection of the device!
→ Operating instructions (supplied with the device)
>
8.1
Install device
42300
►
Install AC412S correctly (→
Install device
>
8.2
Connect the device to the periphery
41574
>
8.2.1
PROFIBUS interface
42243
If the device is to be operated as PROFIBUS device:
►
Connect the device to PROFIBUS network via the PROFIBUS interface (X6/X7).
>
8.2.2
Configuration interface
41596
To access the device via the configuration interface (e.g. web interface, programming interface of the
device-internal CODESYS PLC):
►
connect the configuration interface (X3) of the device to the programming PC/laptop directly or via an Ethernet network.
Details: →
Configuration interface: connection concepts
(→ S.