05.10.2022
Page 11 / 86
Ecomod Heat Pump Control -
Installation and Servicing
3. INSTALLATION
3.1. Installation of the control panel
3.1.1. Installation recommendations
The Ecomod Heat Pump Control control panel must be installed in a technical area.
Avoid installing the regulating system under a water pipe.
The equipment is intended to be wall mounted, using screws and anchors supplied (to
be adapted to suit the wall structure), at operator height to facilitate the use of the control
panel display.
3.1.2. Version with mounting feet
- Open and remove the door by removing the hinge pins shown in figure 6 from the
outside.
- Attach the mounting feet using the four screws supplied in the bag.
- Refit the door by proceeding as for removal but in the reverse order.
- Mount the case level using the screws provided.
3.1.3. Version without mounting feet
figure 5 - Screw locations
Hinge pin
locations
-
Open and remove the door by removing the
hinge pins shown in figure 6 from the outside.
- Insert the anchors into the wall (if required) using
the holes in the case as a pattern, see figure 7.
- Mount the case level using the screws provided.
- Refit the door by proceeding as for removal but
in the reverse order.
figure 6 - Door hinge pin locations
Screw location
holes
figure 7 - Screw locations
