IC Bus Gasoline CE Series, Руководство по эксплуатации и обслуживанию

Страница: 190 / 241

Maintenance Instructions
WARNING
To prevent personal injury and / or death, or
property damage, do not exceed the pressure
rating on the deaeration tank cap. Ensure that
the pressure rating of the deaeration tank cap
matches that listed on the side of the tank, or the
tank may burst.
CAUTION
To prevent property damage, if the coolant should
get extremely low and the engine very hot, let the
engine cool for approximately 15 minutes before
adding coolant. Then, add coolant slowly with
the engine running. Adding cold coolant to a hot
engine may crack the cylinder head or crankcase.
Never use water alone.
Make sure that coolant level is maintained between the COLD
MIN and COLD MAX lines on the deaeration tank when engine
is cold.
Gravity-Fill Coolant Method (PSI 8.8L gasoline Engine)
Filling Instructions
NOTE: Using the KL5007NAV Coolant Management Tool
is the recommended procedure to fill the cooling system,
however, in some cases this tool may not be available, and
the following gravity-fill procedure may be used instead.
Contact an IC Bus
® or International ® dealer for special
instructions on filling the coolant system.
NOTE: This is a traditional gravity-fill-only method that
involves pouring or pumping the coolant into the deaeration
tank of the cooling system and using a combination of
gravity and engine operation to purge the system of air.
It may be necessary to run the engine at various speeds
for up to an hour after filling, followed by a 10 - 12 hour
cooldown and top off, to avoid releasing a vehicle that can
be approximately 1 gallon low on coolant.
176