IC Bus Gasoline CE Series, Руководство по эксплуатации и обслуживанию

Страница: 162 / 241

Roadside Emergencies
Engage the latches at both sides of cowl.
Emergency Starting Using Jumper Cables
WARNING
To prevent personal injury and / or death, or
property damage, the following procedures must
be performed exactly as outlined, otherwise a fire
or a battery explosion could occur.
CAUTION
To prevent damage to vehicle electronic
components, voltage supplied to a vehicle's
electrical system must never exceed 16.0 volts.
This voltage must not be exceeded when the
ignition switch is in the OFF, ACC, position or
during engine cranking. The most reliable means
for jump starting a vehicle is to use batteries
connected so as to provide 12 volts. Never use
an electric welder.
1. Remove metal rings or watches and do not allow metal
tools to contact positive terminal of battery to prevent
shorting of the electrical system.
2. Place transmission in Neutral and set parking brake in
both vehicles.
3. Turn OFF lights, heater, air conditioner and any other
electrical loads in both vehicles.
4. Eye protection should be worn if available. If not
available, shield eyes when near either vehicle’s
batteries.
5. Make sure the vehicle bodies or bumpers are not
touching.
6. Connect one end of the first jumper cable to positive (+)
terminal of the dead battery or (+) terminal of jump start
stud and then the other end to the positive (+) terminal
of the booster battery.
7. Connect one end of the second jumper cable to negative
(-) terminal of the booster battery and the other end to
chassis frame of the vehicle with the discharged battery.
Do not attach the other end to the negative (-) battery
terminal of the discharged battery, because a spark
could occur and cause explosion of gases normally
present around the battery.
8. Reverse above procedure when removing the jumper
cables.
148