IBM xSeries 455, Руководство по установке опций, Страница: 73 / 86

Serial connector
Use a serial connector to connect a serial device. The following illustration shows a
serial connector.
1 5
6 9
Configure a serial console device to accept the following settings:
Baud rate 115200
Data bit 8
Parity None
Stop bits 1
Flow control None
SMP Expansion Port connectors
Use an SMP Expansion Port connector to connect nodes for multi-node
configurations. The following illustration shows an SMP Expansion Port connector.
2
1
48
47
Universal Serial Bus connectors
Use a Universal Serial Bus (USB) connector to connect a USB device. USB
technology transfers data at up to 12 Mb per second (Mbps) with a maximum of
127 devices and a maximum signal distance of 5 meters (16 ft) per segment. Using
Plug and Play technology, USB devices are configured automatically. The following
illustration shows a USB connector.
1 4
Use a 4-pin cable to connect devices to USB 1, USB 2, and USB 3. If you plan to
attach more than three USB devices, you must use a hub to connect the devices.
Video connector
The integrated video controller provides the video connector. The connector is on
the rear of the server. The following illustration shows a video connector.
1 5
11 15
Chapter 3. Input/output connectors
61