IBM x3800 - System - 8865, Руководство пользователя

Страница: 152 / 196

v
After you replace the battery, you must reconfigure the server and reset the
system date and time.
v To avoid possible danger, read and follow the following safety statement.
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v
Throw or immerse into water
v Heat to more than 100°C (212°F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To remove the battery, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 115.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Unlock the front cover (tower model only) and remove the top cover (see
“Removing the top cover, bezel, and front cover” on page 119).
4. Note the location of the cables connected to the I/O board; then, remove the
cables from the I/O board.
5. Remove the I/O board (see “Removing the I/O board” on page 139) and place
the board on a static-protective surface with the battery facing up.
6. Remove the battery:
a. Use one finger to press the top of the battery clip away from the battery.
b. Lift and remove the battery from the socket.
Replacing the battery
To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the replacement battery:
136
IBM System x3800 Type 8865: Problem Determination and Service Guide