IBM x3800 - System - 8865, Руководство пользователя

Страница: 150 / 196

5. Connect the cables and power cords (see “Connecting the cables” on page 118
for cabling instructions).
6. Turn on all attached devices and the server.
Removing the support structure
To remove the support structure, complete the following steps.
Latches
Alignment tabs
Alignment pins
Cable retention
clip
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 115.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Unlock the front cover (tower model only) and remove the top cover (see
“Removing the top cover, bezel, and front cover” on page 119).
4. Remove the memory cards (see “Removing and replacing a memory card” on
page 126).
5. Disconnect the cables from the I/O board that pass through the support
structure; then, open the cable retention clip and place the cable in the structure
6. Pull the two blue latches on the support structure toward the front of the server;
the structure will disengage from the chassis.
7. Grasp the handle in the middle of the structure and rotate the structure up,
allowing the structure to pivot at the chassis front. Guide the cables through the
slot in the bottom of the structure.
8. Lift the structure out of the server, and make sure that the alignment tabs clear
the chassis.
9. If you are instructed to return the support structure, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
134
IBM System x3800 Type 8865: Problem Determination and Service Guide