IBM System x3610, Руководство по диагностике и обслуживанию

Страница: 95 / 144

1. Place the power backplane behind the fan assembly; then, slide the power
backplane toward the right side of the server until the power backplane aligns
with the power-supply enclosure.
2. Align the screw holes in the power backplane with the holes in the bottom of the
chassis; then, replace the screws that secure the power backplane to the
bottom of the chassis.
3. Install the system-board (see “Installing the system board” on page 81).
4. Connect the cables from the power backplane to the following locations:
Table 11. Power backplane cable connections
Location Cable to connector
System board
P1 to J31
P2 to J39
P3 to J14
P8 to J50
Hard disk drive backplane
P4 to J18 (power for the left side of the hard disk drive
backplane)
P5 to J19 (power for the right side of the hard disk drive
backplane)
Optical drive (CD/DVD
drive)
P7 to rear of CD/DVD drive
Be sure to route and secure the cables using the cable ties and bridges located
along each cable route.
5. Install the cover (see “Installing the cover” on page 46).
6. Install the power supplies into the power-supply bays (see “Installing a power
supply” on page 55).
7. Slide the server into the rack and tighten the rack release thumbscrews.
8. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Removing the hot-swap hard disk drive backplane
To remove the hot-swap hard disk drive backplane, complete the following steps.
Latch
SAS backplane
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 43.
Chapter 4. Removing and replacing server components
77