IBM System x3610, Руководство по диагностике и обслуживанию

Страница: 79 / 144

7. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
8. Start the BIOS Setup Utility program and reset the configuration.
v Set the system date and time.
v
Set the user password.
v Reconfigure the server.
See “Using the BIOS Setup Utility program” on page 16 for details.
Removing and replacing Tier 2 CRUs
You may install a Tier 2 CRU yourself or request IBM to install it, at no additional
charge, under the type of warranty service that is designated for your server.
The illustrations in this document might differ slightly from your hardware.
Removing a fan
Attention: To ensure proper server operation, if a fan fails, replace it as soon as
possible.
To replace a fan, replace the fan-bracket assembly. See “Removing the fan-bracket
assembly” on page 67.
Installing a fan
For proper cooling, the server requires that all three fans are functioning.
Attention: To ensure proper server operation, if a fan fails, replace it as soon as
possible.
To replace a fan, replace the fan-bracket assembly. See “Removing the fan-bracket
assembly” on page 67 and “Installing the fan-bracket assembly” on page 68.
Removing the operator information panel assembly
The operator information panel is on top of the DVD enclosure. To remove the
operator information panel assembly, complete the following steps.
Chapter 4. Removing and replacing server components
61