IBM System x3610, Руководство по диагностике и обслуживанию

Страница: 81 / 144

2. Rotate the operator panel assembly into the opening in the front of the server
until it clicks into place.
3. Place the cables through the clips that are on top of the DVD drive cage
assembly, then route them in front of the fans and connect them to the system
board. See “System-board internal cable connectors” on page 9 for the
connector location.
4. Install the cover (see “Installing the cover” on page 46).
5. Slide the server into the rack and tighten the rack release thumbscrews.
6. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Removing the front USB connectors
The front USB connectors are on top of the DVD drive cage assembly.
To remove the front USB connectors, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 43.
2. Turn off the server and peripheral devices, and disconnect the power cord and
all external cables.
3. Remove the cover (see “Removing the cover” on page 46).
4. Remove the fan-bracket assembly (see “Removing the fan-bracket assembly”
on page 67).
5. Remove the DVD drive cage assembly.
a. Disconnect the cables from the rear of the drive.
b. Remove the screws that secure the drive enclosure to the chassis.
c. Slide the drive enclosure toward the rear of the server slightly; then, lift the
drive enclosure out of the server.
Chapter 4. Removing and replacing server components
63