IBM SelectaDock III, Руководство пользователя

Страница: 50 / 134

Setting Up an IDE Device
If you installed an IDE device in the SelectaDock system, make sure
that an IDE controller is enabled. This procedure depends on the
operating system in your computer.
For DOS
For the ThinkPad 760 and 765 user, do as follows:
1
At the DOS command prompt, enter:
PS2 ? IDE2
to show the status of the IDE adapter.
2
If it is disabled, enter:
PS2 IDE2 Enable
to enable it.
3
Reboot the computer to make the change effective.
You have finished the setup.
For the ThinkPad 770 user, do as follows:
1
Select a PCI IRQ with the PS2 ? PCIIRQ command.
2
Reboot the computer to make the change effective.
3
At the DOS command prompt, enter:
PS2 ? IDE3
to show the status of the IDE adapter.
4
If it is disabled, enter:
PS2 IDE3 Enable
to enable it.
Note:
Do not use IRQ 11 and IRQ 15. You have to disable a
device or port to set an IRQ for the SelectaDock III system.
When you select an IRQ, a hardware conflict message
appears. Disable the device currently assigned to that IRQ.
3-2
IBM ThinkPad SelectaDock III User's Guide