IBM Power System System E950, Руководство пользователя

Страница: 33 / 56

Figure 11. Installing or replacing an NVMe U.2 drive in the 9040-MR9 system
Preparing the 9040-MR9 system for operation after removing and replacing
an NVMe U.2 drive
To prepare the system for operation after removing and replacing an NVMe U.2 drive, complete the steps
in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Choose from the following options:
• If the system power is turned off, continue with step “3” on page 19.
• If you are using the AIX operating system, continue with step “5” on page 20.
• If you are using the Linux operating system, continue with step “8” on page 21.
3. Using your labels, reconnect the power cords (A) to the system unit as shown in the following figure.
Fasten the power cords to the system by using the hook-and-loop fasteners (B) as shown in the
following figure.
NVMe U.2 drives for the 9040-MR9 19