IBM HS40 - BladeCenter - 8839, Инструкция по установке и эксплуатации

Страница: 86 / 120

Service processor problems
Symptom Suggested action
The service processor reports
a general monitor failure.
Shut down the operating system and turn off the blade server; then, remove the
blade server from the BladeCenter unit, wait for 30 seconds, reinstall the blade server
in the BladeCenter unit, and restart the blade server.
If a problem remains, call for service.
Light path diagnostics
If the system-error LED on the system LED panel on the front or rear of the
BladeCenter unit is lit, one or more error LEDs on the BladeCenter I/O board and
processor board also might be lit. These LEDs help identify the cause of the
problem.
Diagnosing problems using the light path diagnostics
To locate the component that caused the error, locate the lit error LED on that
component.
The following illustration shows the LEDs on the processor board.
Microprocessor mismatch
error LED (DS5H3)
Light path diagnostics
button (SW9J1)
Light path
diagnostics
LED (green)
(DS9J1)
DIMM 1 error LED (DS6C1)
DIMM 2 error LED (DS6D1)
DIMM 3 error LED (DS6D2)
DIMM 4 error LED (DS6E1)
DIMM 5 error LED (DS6F1)
DIMM 6 error LED (DS6G1)
DIMM 7 error LED (DS6G2)
DIMM 8 error LED (DS6H1)
Microprocessor 2 error LED (DS5H4)
Microprocessor 1 error LED (DS5H5)
Microprocessor 3 error LED (DS5H1)
Microprocessor 4 error LED (DS5H2)
Microprocessor socket 3
Microprocessor socket 2
Microprocessor socket 4
Microprocessor socket 1
DIMM 1
DIMM 2
DIMM 3
DIMM 4
DIMM 5
DIMM 6
DIMM 7
DIMM 8
72
BladeCenter HS40 Type 8839: Installation and User’s Guide