IBM HS40 - BladeCenter - 8839, Инструкция по установке и эксплуатации

Страница: 39 / 120

3. Press the bezel-assembly release and rotate the bezel assembly away from the
blade server chassis; then, unhook the tabs on the bottom of the bezel from the
holes on the server chassis and remove the bezel.
Bezel-assembly release
Bezel-assembly release
4. Disconnect the control-panel cable from the control-panel connector.
Control-panel
cable
Control-panel
connector
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
Installing an IDE drive
Your blade server has two connectors on the I/O board for installing an optional
2.5-inch HS20 IDE Hard Disk Drive or BladeCenter Flash Disk Drive. Each IDE
connector is on a separate bus. Some models might come with at least one hard
disk drive or one flash drive already installed.
Note: In this document, both types of drives are referred to as IDE drives.
Each IDE connector is on a separate bus. Depending on your blade server, at least
one IDE hard disk drive might already be installed. If your blade server is equipped
with one IDE hard disk drive, you can install an additional IDE hard disk drive.
These two IDE hard disk drives can be used to implement and manage redundant
Chapter 3. Installing options
25