IBM eserver xSeries 350, Руководство пользователя, Страница: 96 / 174

84
IBM® xSeries 350: User’s Reference
POST error messages
The following tables provide information about the POST error messages that can
appear during startup.
1-2-4 RAM refresh verification has failed. Reseat the memory modules or install a
memory module. If the problem persists,
call for service.
Attention: In some memory
configurations, the 3-3-3 beep code might
sound during POST followed by a blank
display screen. If this occurs and the Boot
Fail Count
feature in the Start Options of
the Configuration/Setup Utility is set to
Enabled
(its default setting), you must
restart the server three times to force the
system BIOS to reset the memory connector
or bank of connectors from Disabled to
Enabled
.
1-3-1 First 64 Kb RAM test has failed.
1-3-2 First 64 Kb RAM parity test has failed.
3-3-1 A memory size mismatch has occurred.
3-3-3 No memory has been detected in the system.
Table 16. POST error messages.
POST message Description
062 The server failed to start on three consecutive attempts.
All caches are disabled. Repeatedly turning the server on and then off or resetting the server
might cause this problem.
Action: Start the Configuration/Setup Utility program and verify that all settings are correct.
Use the Cache Control selection in the Advanced Setup menu of the
Configuration/Setup Utility program to enable the caches.
If the problem persists, call for service. When the problem is corrected, be sure to enable the
caches.
101
102
106 An error occurred during the system board and microprocessor test.
Action: Call for service.
114 An adapter read-only memory (ROM) error occurred.
Action: Remove the options. If you can start the server without the options installed, reinstall
each option one at a time and retest after each is reinstalled. When an option fails,
replace it.
If you cannot isolate and correct the problem, call for service.
Table 15. POST beep codes.