IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 93 / 158

Removing a management module
To remove a management module or filler, complete the following steps.
Notes:
1. If you are replacing the only management module in the BladeCenter HT unit
and the management module is functioning, save the configuration file before
you proceed. See the
BladeCenter Management Module User’s Guide and the
BladeCenter Management Module Command-Line Interface Reference Guide
for instructions for saving and restoring a configuration file.
2. If you have just installed a second management module in the BladeCenter HT
unit, do not remove the first (primary) management module for up to 45
minutes; the second (redundant) management module needs the time to receive
initial status information and firmware levels from the primary management
module.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Remove the bezel, if installed, to access the management module to be
removed (see “Removing a bezel collar” on page 41).
3. Disconnect all cables from the module.
4. Pull the release handle to the open position. The module moves out of the bay
approximately 0.6 cm (0.25 inch).
5. Slide the module out of the bay. Within 1 minute, install either another
management module or a filler into the bay.
6. If you are instructed to return the management module, follow all packaging
instructions and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing BladeCenter HT components
75