IBM BladeCenter HT 8740, Руководство по диагностике и обслуживанию

Страница: 84 / 158

Removing a high-speed I/O-module interposer tray
To remove a high-speed I/O-module interposer or interposer tray, complete the
following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Remove the bezel as needed to access the high-speed I/O-module interposer to
be removed (see “Removing a bezel collar” on page 41).
3. If an I/O module or filler is installed in the I/O bay, remove it (see “Removing a
high-speed I/O module” on page 71).
4. Make sure that the I/O-module interposer release handle is in the open position.
5. Pull the release handle to the open position. The module moves out of the bay
approximately 0.6 cm (0.25 inch).
6. Slide the module out of the bay.
7. If you are instructed to return the interposer, follow all packaging instructions
and use any packaging materials for shipping that are supplied to you.
66
BladeCenter HT Type 8740 and 8750: Problem Determination and Service Guide